Comments

• 

  Francesca Luciano June 5, 2012 at 1:58am

  Hi Floster, 

  many thanks! 

  The workshop it'll hold in english. Below I also link to the site of this workshop: http://www.digitalmedworkshop.com/ :)
• 

  Carl Christofferson May 28, 2011 at 10:30am

  Here are the pavilion files if you are still interested.
  http://www.grasshopper3d.com/forum/topics/zollinger-grid-construction
• 

  Carl Christofferson May 8, 2011 at 3:58pm

  Hi,

   

  Thanks for your comments about my work. I will try to explain my approach, and I could also later share my grasshopper file with you, but right now I'm on diffrent computer.

   

  What I did was to use the surface morph (a very handy component) to place a grid of lines upon two surfaces facing each other. Then i simply used these lines to build up the 3D geometry, by making a "unit" surface inbetween each pair of lines, then giving thickness to the unit surfaces, and continuing with making joints and calculating intersections.

   

  From there i took a wireframe "section" of each piece, holding information about the shape with holes and joints (extensions). These sections i oriented flat next  to each other in the XY-plane, complete with numbering labels. I exported the contour lines/"sections" into AutoCAD, organized them onto a couple of sheets with the right dimension to fit the printer etc, and then the lasercutter did the rest.

   

  Hope that was somewhat understandable! Best luck with your future explorations of the "real world" :)
• 

  Tommi M February 19, 2011 at 3:04pm

  Hi Florian,

  you're right, i missed your post about! many thanks for the answer! i've read the message and now i'm gonna try to do that: i've understood you work like this

  - make a grid with GH on the surface, and set up the circole in each peaces of surface the grid do, then the curve attractor that transform cicle from small up to big (ref the distance)

  - than you bake it and use the command Split of Rhino to create holes so you have your pierced surface you can after extrude and work as you want!

   

  Thanks again! you're very kind to answer me, the new dummy of the situation! :-)

  Tommi